Toa SX-2000 Series - Manual (Page 41)

The following screen is displayed.
[Checking to confirm if the system has been reset]
If the system has been reset, the fluorescent display on the front panel of the SX-2000AI, SX-2100AI, SX-
2000AO and SX-2100AO goes off and then switches back on, causing the current broadcast to pause.
The Standby indicator remains lit while the system is being reset and goes off after reset is completed.
[When the system cannot be reset]
Check the following items:
1) The SX-2000SM's Standby indicator remains lit.
The internal circuitry of the SX-2000SM in use is not compatible with the system reset, disabling resets
initiated by the setup software. Press the SX-2000SM's [Reset] key to reset the system. (For details, refer
to the separate Installation Manual.)
2) Analog link cables are not connected.
To reset the entire system, connect all SX-2000SM, SX-2000AI, SX-2100AI and SX-2000AO units within
the system in advance using their analog link connectors. Note that the unit not connected through analog
link connectors is not reset. (For details, refer to the separate Installation Manual, "Analog Link Terminal
Connections.")
3) The SX-2000SM's DIP switch is set to "write protect."
Set the DIP switch to the "System Reset ON" position.
(For details, refer to the separate Installation Manual, "System Reset enable/disable Settings (DIP Switch 3
Operation).")
After changing the DIP switch setting, press the [System reset] button again.
Step 3. Click the [OK] button to close the dialog.
41
BASIC SETTINGS
Resetting the System