Toa SX-2000 Series - Manual (Page 176)

176
PRINTING LABELS FOR REMOTE MICROPHONES
Step 2. Using the "Save in" pull-down menu, select the folder where the data for label print is to be saved.
Step 3. Set a "File name."
Notes
• The filename "sx2k2nd.xls" is assigned by default.
• When changing the filename, be sure to add a filename extension (xls).
Example: 0605rm_label.xls
Step 4. Press the [Save] button.
Read of the data for printing labels starts.
The screen below is displayed during data read.
Based on their ID numbers, separate worksheets are produced in the resulting Excel file (book) for
each RM-200SF or RM-200SA unit connected to the SX-2000AI or SX-2100AI.
The initial printing range for each ID number is 1 page for the RM-200SF or RM-200SA. It is also 1
page for the RM-210 when an RM-210 is connected to the RM-200SF or RM-200SA, and this applies
even if multiple RM-210 units are connected.
Step 5. Open the saved .xls (Excel) file and print.
Notes
• The actual print area and the width of the printed label may vary slightly depending on the type of
printer used.
• If the labels cannot be printed out correctly, refer to the separate Installation Manual, "Creating
remote microphone name labels."
• The paper used for the name label must be under 0.2 mm in thickness.
The screen below is displayed after the data read has been completed.