Toa SX-2000 Series - Manual (Page 17)

17
3.3. Setting Procedures
3.3.1. Offline operation
3.3.2. Online operation
The following procedure is recommended when performing settings online.
1. Perform all settings using the SX-2000 software.
2. Output setting data file and save it to a CF card.
(Refer to p. 167 "Saving the Settings File.")
3. Insert the CF card into the SX-2000SM to read the setting data.
(Refer to the separate Installation Manual, "Inserting a CF card.")
1. Connect all SX-2000 system components.
(Insert the CF card into the SX-2000SM in advance.)
(For details, refer to the separate Installation Manual.)
2. Use a cable to connect the SX-2000SM to a PC installed
with the SX-2000 software.
(Refer to p. 155, Step 1 of "Establishing Communications Between the SX-2000SM and a PC.")
3. Set up the SX-2000SM network with the SX-2000 software.
(Refer to p. 29 "(3) Network Settings" of "Basic Settings,"
p. 31 "Detecting the SX-2000SM's Network Settings,"
p. 38 "Changing the SX-2000SM's Network Settings."
5. Acquire the system configuration data through configuration reception.
(Refer to p. 161, "Acquiring System Configuration Data Online.")
6. Perform settings other than system configuration.
7. Write the setting data from PC to the CF card online.
(Refer to p. 159, "Writing Setting Data to the CF Card Online.")
4. Connect and establish communications between the SX-2000SM and the PC.
(Refer to p. 155, Step 2 of "Establishing Communications Between the SX-2000SM and a PC.")