Toa SX-2000 Series - Manual (Page 95)

95
EVENT SETTINGS
Function Description
[Operation example 1]
Normal
Control input 1
(Emergency broadcast pattern 1 start)
ON
ON
ON
Control input 4
(Emergency broadcast pattern 1 stop)
(Phase 1) (Phase 2) (Emergency reset)
Control input 7
(Emergency reset)
"EV1" is broadcast to the
zones assigned to the
output zone pattern 1 for
5 minutes.
Control output pattern 1: ON "EV2" is broadcast
continuously to the zones
assigned to the output zone
pattern 2.
Control output pattern 2: ON
"EV5" is broadcast to
the zones assigned to
the output zone
patterns 1 and 2.
Broadcast status Emergency
Operations in this example are as follows.
• Phase 1 automatically shifts to Phase 2 when the preset time has elapsed.
• EV message "EV2" set to "Continuous broadcast" stops with the control input 4 ("Emergency broadcast
pattern 1 stop" signal) or the control input 7 ("Emergency reset" signal).
• Emergency broadcast status continues even if the emergency broadcast pattern stops. It will return to
normal broadcast status after Reset EV message is broadcast by the control input 7 ("Emergency Reset"
signal).