VACUUBRAND PC 600 LAN NT - Manual (Page 71)

page 71 of 102
Command Operation Response Description
IN_STAT
status process
control
0XXXXX
1XXXXX
X0XXXX
X1XXXX
XX0XXX
XX1XXX
XXX0XX
XXX1XX
XXXX0X
XXXX1X
XXXX2X
XXXX4X
XXXXX0
XXXXX1
XXXXX2
XXXXX3 pump off
pump on
in-line valve closed
in-line valve open
coolant valve closed
coolant valve open
venting valve closed
venting valve open
VACUU•LAN
continuous pumping
vacuum control
RC 5 / RC 6 management
control off
pump down
set vacuum reached
current pressure below set vacuum
IN_ERR fault status
0XXXXXXXX
1XXXXXXXX
X0XXXXXXX
X1XXXXXXX
XX0XXXXXX
XX1XXXXXX
XXX0XXXXX
XXX1XXXXX
XXXX0XXXX
XXXX1XXXX
XXXXX0XXX
XXXXX1XXX
XXXXXX0XX
XXXXXX1XX
XXXXXXX0X
XXXXXXX1X
XXXXXXXX0
XXXXXXXX1
no fault at pump
fault at pump
no fault at in-line valve
fault at in-line valve
no fault at coolant valve
fault at coolant valve
no fault at venting valve
fault at venting valve
no overpressure
overpressure
no fault at pressure transducer
fault at pressure transducer
no external fault, catchpot not full
external fault, catchpot full
no internal fault
internal fault (over temperature at
relay)
last interface command correct
last interface command incorrect
IN_SP_1 set vacuum XXXX mbar/Torr/hPa unit according to preselections
IN_SP_2 maximum speed XXX% 1-100% (100% = ”HI”)
IN_SP_3
switching
pressure
XXXX mbar/Torr/hPa
unit according to preselections
(switching pressure for
VACUU•LAN or two point control)
IN_SP_4 delay XX:XX h:m
hours:minutes
(00:00 = Off)