DMP Electronics DMP Command Processor Panel XR500 - Manual (Page 48)

XR500 Series Canadian Programming Guide Digital Monitoring Products
39
MENU DISPLAY
Menu Display
14.1
MENU DISPLAY
Menu Display
Menu Display allows you to select at which keypad addresses the user can access the
following functions.
To select a keypad, enter the device number (keypad address) using the digit keys
on the keypad. When a keypad is selected, an asterisk appears next to the keypad
address. Enter the number again to deselect the keypad. Press the COMMAND key
to display the next set of keypads (9 through 16). Refer to the Multiple Displays
section at the beginning of this document.
14.2
ARMED STATUS:
Armed Status
Enter the keypad addresses (1 through 16) that show the armed areas. The User
Menu Armed Areas function also displays the custom area name you enter in Area
Information.
When only areas one to eight are used, the Armed Status display is 1 2 3 4 5 6 7 8.
When areas nine or higher are used the system Armed Status display reads ALL
SYSTEM ON or SYSTEM ON. Press the COMMAND key to display additional areas.
Refer to the Multiple Displays section at the beginning of this document and in the
XR500 User’s Guide (LT-0683CAN).
14.3
TIME DISPLAY:
Time
Enter the keypad addresses that can display the time and day of the week.
14.4
ARM/DIS DISPLAY:
Arm/Disarm
Enter the keypad addresses from which users can arm and disarm areas.