Ditch Witch JT100AT - Manual (Page 133)

Conduct a Bore - 132
JT100/JT100 All Terrain Operator’s Manual
Remove Pullback Device
CMW
©
Remove Pullback Device
The pullback device can be removed when the last pipe is on the frame. It can also be removed when a
target pit along the bore path has been reached. Remaining pipe is then pulled back and removed.
1. Press bottom of drilling unit throttle switch until engine is at low throttle.
2. Turn off drilling fluid.
3. Turn drilling unit engine off.
4. Clean pullback device.
5. Use EZ-Connect or Hydratong wrenches to remove pullback device. See “Hydratong Wrenches” on
page 165.
Moving tools will kill or injure. Shut off drill string power
when anyone can be struck by moving or thrown tools. Never use pipe
wrenches on drill string.