Ditch Witch JT100AT - Manual (Page 140)

JT100/JT100 All Terrain Operator’s Manual
Systems and Equipment - 139
Driver/Loader Attachment
CMW
©
Remove/Install Pipe Box
Prepare Loader/Driver Attachment
1. Set auxiliary stabilizer.
• Remove bolt and remove tube cap on track frame
(shown).
• Insert stabilizer fully into right track frame until
hole on tab is lined up with tab on track frame.
• Insert bolt to maintain position of stabilizer but do not tighten nut/bolt.
• Rotate handle clockwise until all slack is removed from stabilizer arm and tube in track frame and
load is supported on stabilizer..
Crushing weight could cause death or serious injury. Use
proper procedures and equipment or stay away.
To help avoid injury:
• Always walk around unit and check for obstructions before moving load.
• Keep objects and personnel clear of loader/driver path during operation.
• Do not take your eyes off moving load. Always look in the direction load is moving.
• Never swing a load over people.
Electric shock will cause death or serious injury. Stay
away.
To help avoid injury: Maintain minimum clearance of 10’ (3 m) between
loader/driver or load being lifted and energized power lines.
NOTICE:
• Auxiliary stabilizer is required for all loader/
driver use on engine side of unit.
• Due to the weight of the stabilizer, use caution
when lifting or use a strap with loader/driver to
assist in the lifting.
NOTICE: If stabilizer does not rest on ground due to holes or grades, it must be blocked up
to provide level and firm support for the unit. When working in soft soil conditions, use wide
pads under stabilizer foot to prevent sinking.
j17om003t.eps