Ditch Witch JT100AT - Manual (Page 18)

JT100/JT100 All Terrrain Operator’s Manual
Safety - 17
Driver/Loader Precautions
CMW
©
Driver/Loader Precautions
Intended Use
The driver/loader is to be used for driving anchors and loading and unloading pipe boxes only. Use in any
other way is considered contrary to the intended use.
Preparation
Visually inspect driver/loader each day to determine that it is in good condition before it is used. Check the
following:
• Make sure driver/loader is free of excess oil, grease, mud and debris before operation.
• Test driver/loader at the beginning of each shift to determine that the operating systems are in good
working order.
• Check safety devices to ensure they are functioning and in place.
• Check boom, hoses and connecting pins for wear and damage.
Transportation
• Always store auxiliary stabilizer before moving unit.
• Always store driver/loader properly for transportation.
• Never drive with load suspended from driver/loader.
Jobsite Setup
• Always use unit stabilizers during driver/loader operation. Ensure that they are firmly positioned on
solid footings.
• Always install auxiliary stabilizer for driver/loader operation on engine side of unit.
• If auxiliary stabilizer rests on curb or other object that prevents it from supporting load, consider
blocking under the arm of the auxiliary stabilizer as near the outer end as possible to support load.
• If auxiliary stabilizer does not rest on ground due to holes or grades, it must be blocked up to provide
level and firm support for the unit.
• When working in soft soil conditions, use wide pad under auxiliary stabilizer foot to prevent sinking.
• Ensure loads are securely attached before lifting.