Echelon OpenLNS Commissioning Tool - Manual (Page 357)

OpenLNS CT User’s Guide 341
Service Pin Options
You can set options for using the service pin when commissioning a device.
Show Service Pin
Data Displays the service pin data received by OpenLNS CT when you
press the device’s service pin. This option is cleared by default.
You can change this option when you commission a device or router
in the Commission Device/Router Wizard.
Scope: Current network, current OpenLNS CT computer
Serialize Service
Pin Access Limits service pin installation to only one installer looking for a
service pin message at a time. This option is selected by default.
Clear this check box if multiple users are commissioning devices at
the same time and are working on different channels connected by
configured routers.
Select this check box if multiple users are commissioning devices at
the same time and are working on channels connected by logical
repeaters, or if multiple users are installing devices on the same
channel.
Either setting can be used if you have a single user commissioning
devices at a time on the network.
Scope: Current network, all OpenLNS CT computers
Filter Based on
Channel Ignores service pin messages not originating from the same channel
on which the device being installed is located. This option is cleared
by default.
Select this check box if the network does not contain any logical
repeaters.
Clear this check box if the network includes any logical repeaters.