Echelon OpenLNS Commissioning Tool - Manual (Page 58)

42 Getting Started
Tips:
• You can click Finish at any point in the Network Wizard. Doing so will skip the subsequent
series of pages, and your new OpenLNS CT network design will be created using the current
settings in the New Network Options tab of the OpenLNS CT Design Manager.
• By default, the subsequent pages in the Network Wizard will appear each time you re-open
the OpenLNS CT drawing. Select the Skip This Prompt when Re-opening this Drawing
check box on any of the pages you want to skip when re-opening the drawing.
• You can change any options you set in the Network Wizard in the OpenLNS CT drawing.
Open the OpenLNS CT menu, click Network Properties, and then click the tab containing
the options you want to modify.
5. Edit the following information as required:
Network Name Displays the network name. By default, this is the current name in
the Network Name box under New Network in the General tab of
the OpenLNS CT Design Manager. The default network name is
incremented if a naming conflict exists.
You can change the name of the network. The name must be unique
to the network database, and it can have a maximum of 16
characters. The network name in the Network Database Path and
Network Drawing Path fields will automatically be updated to
match the name you specify.
Recover Database
from Network Opens the OpenLNS Database Recovery Wizard after completing
the Network Wizard. You can use the recovery wizard to create a
new OpenLNS CT drawing and network database from an existing
operational network.