BINDER MK 115 User Manual
Page 12
MKF + MKFT (E3.1) 07/2014
page 12/114
5.3
Behavior after power failure .............................................................................................................. 42
5.4
Behavior when opening the door ...................................................................................................... 42
5.5
Turning on the unit ............................................................................................................................ 43
6.
CONTROLLER MB1 SETTINGS .......................................................................... 44
6.1
Selection of the menu language ....................................................................................................... 44
6.2
Function overview program controller MB1 ...................................................................................... 45
6.3
Menu settings in the “User-settings” menu ....................................................................................... 46
6.4
Menu settings in the “User Level” menu ........................................................................................... 47
7.
GRAPHIC REPRESENTATION OF THE HISTORICAL MEASUREMENT
(CHART RECORDER FUNCTION) ...................................................................... 48
7.1
Setting the storage rate ..................................................................................................................... 50
8.
MANUAL MODE ................................................................................................... 51
8.1
Set-point entry ................................................................................................................................... 51
8.2
Performance after power failure in Manual Mode ............................................................................. 53
9.
PROGRAM OPERATION ..................................................................................... 53
9.1
Menu-based program entry ............................................................................................................... 53
9.2
Entering the temperature values and the switching states of the operation lines............................. 54
9.3
Entering the humidity values ............................................................................................................. 56
9.4
Selecting between set-point ramp and set-point step ....................................................................... 57
9.5
Program entry as set-point ramp or as set-point step ....................................................................... 57
9.6
Information on programming different temperature or humidity transitions ...................................... 62
9.7
Repetition of a section or several sections within a program ............................................................ 63
9.8
Performance after power failure in Program Mode ........................................................................... 63
9.9
Starting a previously entered program .............................................................................................. 64
9.10
Deleting a program ............................................................................................................................ 64
9.11
Temperature profile and operation lines template ............................................................................ 65
9.12
Humidity profile template ................................................................................................................... 66
9.13
Program table template for temperature and operation lines ........................................................... 67
9.14
Program table template for humidity ................................................................................................. 68
10.
BEDEW PROTECTION FACILITY (OPERATION LINE 1) .................................. 69
11.
ZERO-VOLTAGE RELAY OUTPUTS VIA OPERATION LINES 2 TO 5 .............. 70
12.
TEMPERATURE SAFETY DEVICES ................................................................... 71
12.1
Over temperature protective device (class 1) ................................................................................... 71
12.2
Safety controller (over-temperature safety device class 2 DIN 12880) ............................................ 71
12.3
Over/under temperature safety device class 2 (option) .................................................................... 73
13.
NOTIFICATION AND ALARM FUNCTIONS ........................................................ 74
13.1
Notification and alarm system overview (auto diagnosis system) .................................................... 74
13.2
Resetting the notification or alarm messages ................................................................................... 75
14.
HUMIDITY SYSTEM ............................................................................................. 76
14.1
Function of the humidifying and dehumidifying system .................................................................... 77
15.
DEFROSTING AT REFRIGERATING OPERATION ............................................ 79
16.
OPTIONS .............................................................................................................. 80
16.1
Communication software APT-COM™ 3 DataControlSystem (option) ............................................ 80
16.2
Interface RS 422 (option) .................................................................................................................. 80
16.3
Analog outputs for temperature and humidity (option) ...................................................................... 80
16.4
Data logger kits ................................................................................................................................. 81
16.5
Keyboard locking (option) ................................................................................................................. 81