BINDER MK 115 - Manual (Page 29)

MKF + MKFT (E3.1) 07/2014 page 29/114
With temperatures below +3 °C / 37.4 °F, water must be completely removed from the humidifying sys-
tem.
CAUTION
Storage below +3 °C / 37.4 °F with filled steam humidifying system.
Freezing in the steam generator.
Damage to the unit.

Contact BINDER Service before any storage below +3 °C / 37.4 °F.
• Permissible ambient humidity: max. 70 % r.H., non-condensing
CAUTION
Condensation by excess humidity.
Danger of corrosion on the housing after operating at humidity values > 70 % r.H.
for a long period.

Dry the appliance completely before shut-down:
• Set the humidity to 0 % r.H. or turn off humidity switch (4).
• Set the temperature set point to 150 °C / 302 °F (Manual mode). Let the unit oper-
ate for approx. 2-3 hours with closed door. Remove the access port plugs.
• Only then, shut down the unit at the main power switch (3) and close the tap of the
water supply.
After drying the unit for decommissioning, the humidity value will approximate ambient humidi-
ty.
When after storage in a cold location you transfer the unit to its warmer installation site, condensation
may form. Before start-up, wait at least two hours until the chamber has attained ambient temperature
and is completely dry and the oil in the compressors has warmed up.
In case of a prolonged temporal decommissioning: Leave the unit door open or remove the access port
plugs.
3.4 Location of installation and ambient conditions
Set up the alternating climate chamber on a flat, even and non-flammable surface, free from vibration,
and in a well-ventilated, dry location and align it using a spirit level. The site of installation must be capa-
ble of supporting the unit’s weight (see technical data, chap. 20.4). The chambers are designed for setting
up inside a building (indoor use).
When after storage in a cold location you transfer the unit to its warmer installation site, condensation
may form. Before start-up, wait at least two hours until the chamber has attained ambient temperature
and is completely dry and the oil in the compressors has warmed up.
CAUTION
Danger of overheating.
Damage to the unit.
∅
Do NOT set up units in non-ventilated recesses.
 Ensure sufficient ventilation for dispersal of the heat.