Axel AX4000 User's Manual - Manual (Page 22)

Setting-Up the Office Server in Interactive Mode
16
AXEL Office Server
2.2.5 - Exiting Set-up Mode
To save the modifications and exit set-up mode, select [Exit] →[Save and exit].
The Office Server settings are stored in NVRAM and the set-up session is
ended.
Note: to abandon your changes and exit set-up mode, select [Exit]→[Exit
without Saving].
2.3 - NETWORK SET-UP
The [Network] menu allows the administrator:
- to configure the Office Server network interface (name, IP address and
netmask),
- to enter data into the host table (name and IP address),
- to enter data into the routing table.
Note: for more information on IP addresses and routers, consult appendix A.1.
2.3.1 - Office Server Network Interface
Select [Network] →[IP Address] and enter the following parameters:
- Name: this is only a local name (not available to a DNS server),
- IP address,
- Netmask: the value used depends on the IP address class (A, B or C).
Modify this mask to correspond to the type of sub-net used.
Note: select the menu [Network] →[Ethernet] to ascertain the Ethernet
address.