Axel AX4000 User's Manual - Manual (Page 26)

Setting-Up the Office Server in Interactive Mode
20
AXEL Office Server
Parameters needed for a modem or dedicated line:
- Hang-Up Type: signal used by the Office Server to terminate the call.
Values: soft, rts or dtr.
- Modem Esc. (requested only if HANG-UP TYPE is soft): HAYES
sequence to return to command mode.
- Modem Hang-Up Seq. (requested only if HANG-UP TYPE is soft):
HAYES sequence to terminate the call.
- Hang-Up on Net Close: if yes (y), the Office Server terminates the call
when the network connection is closed. If no (n), the modem does not
hang up when the network session is closed.
- Net Close on Hang-Up: if yes (y), the network service is closed when
the modem hangs up. If no (n), the network session is not closed when
the modem line is dropped.
- Line Inactivity Timeout: If the line is inactive for a predefined number of
minutes, the Office Server automatically terminates the call (HANG-UP
TYPE). If the number of minutes is '0', this feature is disabled.
For safety reasons, please enable this feature at the modem level by
using the proper HAYES sequence.
- Modem Reset Seq.: HAYES sequence to reset the modem (factory set-
up).
- Modem Init Seq.: HAYES sequence to initialise the modem.
- Phone Seq. (not available for a dedicated line): phone number of the
remote site (used when the Office Server dials the modem).
For more information about using modems, see appendix A.5.
2.4.2 - Duplicating Serial Line Settings
The Office Server allows duplication of a given serial line configuration. Select
[Serial Lines]
→[Duplicate] and enter the following parameters:
- source: number of the source serial line
- destination: four values are available:
- a serial line number,
- a comma separated list of serial line numbers (e.g.: 1,3,4),
- a range of serial line numbers (e.g.: 2-4),
- the command option 'all'.
After confirmation, the line settings (line parameters, modem settings and
network service) are copied onto the target serial line(s).