Axel AX4000 User's Manual - Manual (Page 90)

Appendix
84
AXEL Office Server
A configuration file can either be created using a text editor, or obtained from an
already configured Office Server (by using rsh setup_get).
When a configuration file is obtained from an Office Server, the inactive
parameters (undefined hosts, network service unused, etc.) are commented
out.
The sample configuration file, shown in the following pages, is typical of a file
obtained from an already configured Office Server. The notes and headings
have been inserted for clarification and would not appear in the file.
Header
BEGIN_AX40x0_SETUP V1.1
#########################################################
# TCP/IP AX40x0 Office Server #
# #
# Ethernet address: 00:A0:34:10:27:10 #
# Firmware: FK3.BV1.1e/FR.9926a #
#########################################################
#
# RESET_CMOS
Note: the RESET_CMOS command allows all set-up parameters (except the
Office Server IP address) to be reset. When the configuration file is obtained
from an Office Server, this RESET_CMOS command is displayed as a comment.
Ethernet Parameters
#ethernet_ipname=192.168.1.241 (character string, 15 char max.)
#ethernet_ipaddr=192.168.1.241 (IP address format)
#ethernet_netmask=255.255.255.0 (IP address format)
Note: When a configuration file is obtained from an Office Server, the
ethernet_xxx parameters are commented out (so that this file can be used
for configuring other Office Servers).