Axel AX4000 User's Manual - Manual (Page 71)

Appendix
AXEL Office Server
65
A.2.1 - UNIX
Use the UNIX System Management Tool to add a remote printer. At least, two
parameters are required:
- the name of the remote host: enter the Office Server's hostname (refer to
/etc/hosts),
- the name of the printer: this is the Queue Name entered when the Office
Server was set up.
Run the lp command to use this printer.
Note: some options of the lp command (number of copies, banner, etc.) cannot
be used, because the Office Server is not a UNIX host system and has no hard
disk on which to run a spooler.
a - Using lpd under IBM AIX V3.x
Enter the SMIT fast path smit mkrque. Four parameters are required:
- Name of Queue to Add:
⇒ name of the printer accessed by the lp command
- Destination Host for Remote Jobs:
⇒ hostname of the Office Server (refer to /etc/hosts)
- Name of Queue on Remote Printer:
⇒ Queue Name associated with the Office Server's port
- Name of Device to Add:
⇒ device name of printer on AIX
b - Using lpd under IBM AIX V4.x
Enter the SMIT fast path smit spooler then select 'Add a Print Queue' and
'Remote'.