Omnia Audio Omnia.11 - Manual (Page 54)

38
turning down the Auto Sense control a little. This will allow more clipping to take place. For more information
about clipper Auto Sense, please see Page 60.
Bass Growl
This is the next control that is important to adjust with each preset that you try. This control is located in both the
Quick Setup tab and in the Advanced tab of the Wide Band / ENH menu.
Bass Growl tunes a number of behind-the-scenes parameters at once to tune the Omnia.11 for the desired amount of
bass. Higher settings cause the bass enhancers in the Basic tab of the ENH menu to be more audible more of the
time. So after making an adjustment to Bass Growl, go back and revisit your Deep/Phat/Warm bass enhancer
settings if needed. Note that the Deep Bass and Warm Bass controls can also be found in the Quick Setup tab. The
Phat Bass control is only found in the ENH / Basic tab. For more information about Phat Bass, please see Page 48.
Brightness
The last 2 basic controls that are important to adjust for each preset tried are the Presence and Treble brightness
controls.
A setting of “0.0” will add no additional brightness to the selected preset. Turn each up to taste but be careful not to
use more than needed since excessive limiter activity or clipping could occur with very high settings. A little goes a
long way here!
Saving User Presets
Once you have made changes to any parameter, such as the controls in the Quick Setup tab discussed above, it is a
good idea to save those changes so they will not be lost. The factory presets cannot be over-written so a new user
preset must be created. This is done from the Preset tab using the Save Current As button.
When you touch Save Current As the on-screen keyboard will pop-up. Use the on-screen keyboard to type a name
for your new preset and then touch “OK”. While up to 20 characters can be shown for each preset in the preset list
window, try to keep the preset names short and descriptive if possible.
If you should want to delete a user preset (factory presets cannot be deleted), touch the Delete button and a new
window opens containing a list of all of the previously saved user presets. 10 user presets are shown per screen so
use the PAGE UP and PAGE DOWN buttons if needed to see more user presets.
When you make new changes to an existing user preset, touch the Save Current button to save the new changes.
Help Text
The new context-sensitive help text feature will pop up a box with information about the currently selected control
when that control is highlighted and then the “?” button in the lower-right hand corner of the menu screen is touched
(or clicked in the remote).