Westermo MDI-112-F4G - Manual (Page 141)

137
Switch(config)# no relay 1 (Relay_ID: 1 or 2)
<cr>
Display Switch# show relay 1
Relay Output Type : Port Link
Port : 1, 2, 3, 4,
Switch# show relay 2
Relay Output Type : Super Ring
Event Selection
Event Selection Switch(config)# warning-event
coldstart Switch cold start event
warmstart Switch warm start event
linkdown Switch link down event
linkup Switch link up event
authentication Authentication failure event
fault-relay Switch fault relay event
power Switch power failure event
sfp Switch SFP event
super-ring Switch super ring topology
change event
time-sync Switch time synchronize event
Ex: Cold Start
event
Switch(config)# warning-event coldstart
Set cold start event enable ok.
Ex: Link Up event Switch(config)# warning-event linkup
[IFLIST] Interface list, ex:
fa1,fa3-5,gi17-18
Switch(config)# warning-event linkup fa5
Set fa5 link up event enable ok.
Display Switch# show warning-event
Warning Event:
Cold Start: Enabled
Warm Start: Disabled
Authentication Failure: Disabled
Link Down: fa4-5
Link Up: fa4-5
Power Failure:
Super Ring Topology Change: Disabled
Fault Relay: Disabled
Time synchronize Failure: Disable