Westermo MDI-112-F4G - Manual (Page 59)

55
Mdix mode is Disable.
Medium mode is Copper.
Switch# show sfp ddm show SFP DDM information
Port 8
Temperature:N/A
Tx power:N/A
Rx power:N/A
Port 9
Temperature:64.00 C <range :0.0-80.00>
Tx power:-6.0 dBm <range : -9.0 - -4.0>
Rx power:-30.0 dBm <range: -30.0 - -4.0>
Port 10
Temperature:67.00 C <range :0.0-80.00>
Tx power:-6.0 dBm <range : -9.0 - -4.0>
Rx power:-2.0 dBm <range: -30.0 - -4.0>
Note: Administrative Status -> Port state of the port.
Operating status -> Current status of the port. Duplex ->
Duplex mode of the port. Speed -> Speed mode of the port.
Flow control -> Flow Control status of the port.
Rate Control
Rate Control –
Ingress or
Egress
Switch(config-if)# rate-limit
egress Outgoing packets
ingress Incoming packets
Note: To enable rate control, you should select the Ingress
or Egress rule first; then assign the packet type and
bandwidth.
Rate Control –
Filter Packet
Type
Switch(config-if)# rate-limit ingress mode
all Limit all frames
broadcast Limit Broadcast frames
flooded-unicast Limit Broadcast, Multicast and flooded
unicast frames
multicast Limit Broadcast and Multicast frames
Switch(config-if)# rate-limit ingress mode broadcast
Set the ingress limit mode broadcast ok.
Rate Control - Switch(config-if)# rate-limit ingress bandwidth