H3C Technologies H3C S7500E Series Switches - Manual (Page 28)

17
Figure 14 Installing an air filter (S7503E)
(1) Fix the fastening strips onto the chassis (2) Push the air filter in between the fastening strips
(3) Fasten the captive screws
Mounting the switch to the rack
CAUTION:
•
Do not hold the handle of the fan tray, power module, or the back cover of the chassis, or the air vents
of chassis. Any attempt to carry the switch with these parts might cause equipment damage or even
bodily injury.
• Use a mechanical lift for switches of a high weight.
• After placing the switch on the slide rails, do not leave go of your hands immediately because this might
tip and damage the switch, and even cause bodily injury.
To mount the switch to the rack:
1. Face the rear of the chassis towards the front of the rack.
2. Use at least two persons to lift the switch until the bottom of the switch is a little higher than the slide
rails on the rack.
3. Place the switch on the slide rails and slide the switch along the slide rails until the mounting
brackets on the switch touch the front rack posts, as shown in callout 1 on
Figure 15 .
4. Fix the chassis to the rack with mounting screws.
1
1
2
3
3