Replacing a cf card, Ut 1 on, Figure 54 – H3C Technologies H3C S7500E Series Switches User Manual
Page 99
88
Figure 54 Removing an air filter for the other models
(1) Loosen the captive screw on the air filter
(2) Pull the air filter out of the chassis
Replacing a CF card
CAUTION:
Do not remove the CF card when the switch is booting or the CF card LED is blinking. Otherwise, the file
system on the hardware or the CF card might be damaged.
Before replacing a CF card, execute the umount command to unmount the CF card to ensure that the file
system on the CF card is not damaged when you remove the CF card.
After you execute the umount cf command, if you want to continue to use the CF card, execute the mount
cf command in user view to load the CF card again.
After you replace the CF card, the system automatically loads the CF card.
To replace a CF card:
1.
Log in to the switch to execute the umount command. For how to log in to the switch, see
"
Connecting your switch to the network
."
2.
Press the eject button of the CF card reader as shown in callout 1 of
. The reader ejects
the card part way out of the slot.
3.
Remove the CF card from the reader and put it in an antistatic shielding bag.
4.
Install a new CF card. For the installation procedures, see "