H3C Technologies H3C S7500E Series Switches - Manual (Page 85)

74
Task Command Remarks
Reboot the standby SRPU (in
standalone mode).
slave restart Available in system view.
Reboot the IRF fabric, a member
switch, or a card (in IRF mode).
reboot [ chassis
chassis-number
[ slot slot-number ] ]
Available in user view.
• If neither chassis nor slot is specified, the
command reboots all member switches.
• If only a chassis is specified, the command
reboots the specified member switch.
• If you specify both a chassis and a slot, the
command reboots the specified card in the
specified switch.
To schedule a reboot of the switch:
Task Command Remarks
Schedule a reboot of the switch
at a specific date and time. schedule reboot at hh:mm
[ date ] By default, no reboot schedules are set.
Available in user view.
Schedule a reboot of the switch
after a specific amount of time. schedule reboot delay { hh:mm
| mm } By default, no reboot schedules are set.
Available in user view.
NOTE:
•
To reboot the switch or the active SRPU by using the reboot command, you must ensure that you have
specified a main boot file.
• The switch prompts "REBOOT IN ONE MINUTE" one minute before the rebooting time and then reboots
in one minute.
• For data security, the switch does not run a scheduled reboot task if you are performing a file operation
at the scheduled reboot time.