Displaying irf topology information – H3C Technologies H3C S7500E Series Switches User Manual
Page 82
71
Field Description
MAC persistent
The bridge MAC address preservation setting of the IRF fabric:
•
6 min—The bridge MAC address of the IRF fabric does not change within six
minutes after the master switch leaves.
•
always—The bridge MAC address of the IRF fabric does not change after the
master switch leaves.
•
no—As soon as the master leaves, the IRF fabric uses the bridge MAC address
of the newly elected master as its bridge MAC address.
Domain ID
IRF domain ID
Displaying the basic IRF settings of IRF member switches
Use the display irf configuration command to display the basic IRF settings of member switches,
including their member IDs, priority, and IRF port bindings.
•
Display the basic IRF settings a member switch when it is operating in standalone mode:
<Sysname> display irf configuration
MemberID Priority IRF-Port1 IRF-Port2
1 1 Ten-GigabitEthernet2/0/1 disable
•
Display the basic IRF settings of all member switches after the IRF fabric is formed:
<Sysname> display irf configuration
MemberID NewID IRF-Port1 IRF-Port2
1 1 Ten-GigabitEthernet1/2/0/1 disable
Ten-GigabitEthernet1/2/0/2
2 2 disable Ten-GigabitEthernet2/3/0/1
Ten-GigabitEthernet2/3/0/2
Table 22 Command output
Field Description
MemberID
Current member ID of the device.
If no member ID has been assigned, this field displays two hyphens (--).
Priority
Member priority.
This field is available only in standalone mode.
New-ID
The member ID re-assigned to the switch. This setting takes effect at reboot.
This field is available only in IRF mode.
IRF-Port1
Ports bound to IRF port 1. To bring up IRF port 1, you must bind at least one
physical port to it. If no ports have bound to IRF port 1, this field displays disable.
IRF-Port2
Ports bound to IRF port 2. To bring up IRF port 2, you must bind at least one
physical port to it. If no ports have bound to IRF port 2, this field displays disable.
Displaying IRF topology information
Use the display irf topology command to display IRF topology information.
<Sysname> display irf topology
Topology Info