H3C Technologies H3C SR8800 - Manual (Page 26)

17
Flow template configuration example
Network requirements
Create flow templates and apply them to interfaces.
Configuration procedure
# Create basic user-defined flow template aaa.
<Sysname> system-view
[Sysname] flow-template aaa basic smac customer-vlan-id
# Reference user-defined flow template aaa on interface GigabitEthernet 2/1/1.
[Sysname] interface Gigabitethernet 2/1/1
[Sysname-GigabitEthernet2/1/1] flow-template aaa
# Display information about user-defined flow template aaa.
[Sysname] display flow-template user-defined aaa
user-defined flow template: basic
name:aaa, index:1, total reference counts:1
fields: smac customer-vlan-id
# Display information about all user-defined flow templates.
[Sysname] display flow-template user-defined
user-defined flow template: basic
name:aaa, index:1, total reference counts:1
fields: smac customer-vlan-id
user-defined flow template: basic
name:1, index:2, total reference counts:0
fields: service-cos
user-defined flow template: basic
name:2, index:3, total reference counts:0
fields: ip-protocol dscp
# Display information about the user-defined flow templates referenced to interfaces.
[Sysname] display flow-template interface
Interface: GigabitEthernet2/1/1
user-defined flow template: basic
name:aaa, index:1, total reference counts:1
fields: smac customer-vlan-id
# Delete user-defined flow template aaa. As it is being referenced by interface Gigabitethernet 2/1/1,
remove it from the interface first.
[Sysname] interface Gigabitethernet 2/1/1
[Sysname-GigabitEthernet2/1/1] undo flow-template
[Sysname-GigabitEthernet2/1/1] quit
[Sysname] undo flow-template name aaa
ACL rule length limit mode configuration example
Network requirements
Configure the ACL rule length limit for an SPE card to 18 bytes and that for an SPC card to 80 bytes.