H3C Technologies H3C SR8800 - Manual (Page 37)

28
NOTE:
•
Do not configure a CIR exceeding the interface bandwidth. Otherwise, the configuration will fail.
• The qos lr command is available for the interfaces on the subcards PIC-GP10L, PIC-GP20R, and
PIC-GT20R.
• The first time you configure the qos lr, queue ef bandwidth, queue af bandwidth, queue wfq, or
remark local-precedence command for a subinterface, you must use the undo qos lr command to
disable line rate on the main interface if none of these commands is configured on any other
subinterfaces.
• Do not configure the qos lr command and the qos gts any command on the same interface or port
group at the same time.
Displaying and maintaining line rate
Task Command Remarks
Display interface line rate
configuration information.
display qos lr interface
[ interface-type interface-number ]
[ | { begin | exclude | include }
regular-expression ]
Available in any view
Line rate configuration example
1. Network requirements
Configure line rate on interface GigabitEthernet 3/1/2 to limit the rate of outgoing packets to 480
kbps.
2. Configuration procedure
# Enter system view.
<Sysname> system-view
# Enter interface view.
[Sysname] interface GigabitEthernet 3/1/2
# Configure line rate on the interface.
[Sysname-GigabitEthernet3/1/2] qos lr outbound cir 480