Configuring basic ipv6 functions, Enabling ipv6 – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 120
109
Task Remarks
Configuring basic IPv6 functions
Required
Configuring an IPv6 global unicast
address
Required to configure one
Configuring an IPv6 link-local
address
Configure an IPv6 anycast address
Configuring a static neighbor entry
Optional
Configuring the maximum number
of neighbors dynamically learned
Optional
Configuring parameters related to
RA messages
Optional
Configuring the maximum number
of attempts to send an NS message
Optional
Optional
Configuring a static PMTU for a
specified IPv6 address
Optional
Configuring the aging time for
dynamic PMTUs
Optional
Configuring IPv6 TCP properties
Optional
Configuring IPv6 FIB load sharing
Optional
Configuring ICMPv6 packet
sending
Configuring the maximum ICMPv6
error packets sent in an interval
Optional
Enabling replying to multicast echo
requests
Optional
Enabling sending of ICMPv6 time
exceeded messages
Optional
Enabling sending of ICMPv6
destination unreachable messages
Optional
Configuring basic IPv6 functions
Enabling IPv6
Enable IPv6 before you perform any IPv6-related configuration. Without IPv6 enabled, an interface
cannot forward IPv6 packets even if it has an IPv6 address configured.
Follow these steps to enable IPv6:
To do...
Use the command...
Remarks
Enter system view
system-view
—