H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 124)

113
• Associate a neighbor IPv6 address and link-layer address with the Layer 3 interface of the local
node.
• Associate a neighbor IPv6 address and link-layer address with a port in a VLAN containing the
local node.
Follow these steps to configure a static neighbor entry:
To do... Use the command... Remarks
Enter system view system-view —
Configure a static
neighbor entry
ipv6 neighbor ipv6-address mac-address { vlan-id
port-type port-number | interface interface-type
interface-number }
Required
CAUTION:
You can use either of the previous configuration methods to configure a static neighbor entry for a VLAN
interface.
• After a static neighbor entry is configured by using the first method, the device must resolve the
corresponding Layer 2 port information of the VLAN interface.
• If you use the second method, ensure that the corresponding VLAN interface exists and that the Layer 2
port specified by
port-type port-number belongs to the VLAN specified by vlan-id. After a static
neighbor entry is configured, the device associates the VLAN interface with the IPv6 address to identify
the static neighbor entry uniquely.
Configuring the maximum number of neighbors dynamically
learned
The device can dynamically acquire the link-layer address of a neighboring node through NS and NA
messages and add it into the neighbor table. A large table may reduce the forwarding performance of
the device. You can restrict the size of the neighbor table by setting the maximum number of neighbors
that an interface can dynamically learn. When the number of dynamically learned neighbors reaches
the threshold, the interface stops learning neighbor information.
Follow these steps to configure the maximum number of neighbors dynamically learned:
To do… Use the command… Remarks
Enter system view system-view —
Enter interface view
interface interface-type
interface-number
—
Configure the maximum number of
neighbors dynamically learned by
an interface
ipv6 neighbors max-learning-num
number
Optional
By default, an interface can learn
up to 256 neighbors dynamically.
Configuring parameters related to RA messages
You can enable an interface to send RA messages, and configure the interval for sending RA messages
and parameters in RA messages. After receiving an RA message, a host can use these parameters to