Configuration procedure – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 152
141
Figure 51 Network diagram for IPv6 static route configuration
Configuration procedure
1.
Configure the IPv6 addresses for all VLAN interfaces (omitted)
2.
Configure IPv6 static routes.
# Configure a default IPv6 static route on SwitchA.
<SwitchA> system-view
[SwitchA] ipv6
[SwitchA] ipv6 route-static :: 0 4::2
# Configure two IPv6 static routes on SwitchB.
<SwitchB> system-view
[SwitchB] ipv6
[SwitchB] ipv6 route-static 1:: 64 4::1
[SwitchB] ipv6 route-static 3:: 64 5::1
# Configure a default IPv6 static route on SwitchC.
<SwitchC> system-view
[SwitchC] ipv6
[SwitchC] ipv6 route-static :: 0 5::2
3.
Configure the IPv6 addresses and gateways for hosts.
Configure the IPv6 addresses for all the hosts based on the network diagram, configure the default
gateway of Host A as 1::1, that of Host B as 2::1, and that of Host C as 3::1.
4.
Display configuration information
# Display the IPv6 routing table of SwitchA.
[SwitchA] display ipv6 routing-table
Routing Table :
Destinations : 5 Routes : 5
Destination : :: Protocol : Static
NextHop : 4::2 Preference : 60
Interface : Vlan-interface200 Cost : 0
Destination : ::1/128 Protocol : Direct
NextHop : ::1 Preference : 0