Network requirements, Configuration procedure – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 173
162
Configuring an additional metric for a RIP interface
Network requirements
As shown in the following figure:
•
RIP is enabled on all the interfaces of Switch A, Switch B, Switch C, Switch D, and Switch E. The
switches are interconnected through RIPv2.
•
Switch A has two links to Switch D. The link from Switch B to Switch D is more stable than that from
Switch C to Switch D. Configure an additional metric for RIP routes received through VLAN-interface
200 on Switch A so that Switch A prefers the 1.1.5.0/24 network learned from Switch B.
Figure 57 Network diagram for RIP interface additional metric configuration
Configuration procedure
1.
Configure IP addresses for the interfaces (omitted).
2.
Configure RIP basic functions.
# Configure Switch A.
<SwitchA> system-view
[SwitchA] rip 1
[SwitchA-rip-1] network 1.0.0.0
[SwitchA-rip-1] version 2
[SwitchA-rip-1] undo summary
[SwitchA-rip-1] quit
# Configure Switch B.
<SwitchB> system-view
[SwitchB] rip 1
[SwitchB-rip-1] network 1.0.0.0
[SwitchB-rip-1] version 2
[SwitchB-rip-1] undo summary
# Configure Switch C.
<SwitchC> system-view
[SwitchB] rip 1
[SwitchC-rip-1] network 1.0.0.0
[SwitchC-rip-1] version 2
[SwitchC-rip-1] undo summary
# Configure Switch D.
<SwitchD> system-view
[SwitchD] rip 1