Bootp client configuration example, Network requirements, Configuration procedure – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 80
Advertising
69
BOOTP client configuration example
Network requirements
As shown in
, Switch B’s port belonging to VLAN 1 is connected to the LAN. VLAN-interface 1
obtains an IP address from the DHCP server by using BOOTP.
Configuration procedure
The following describes only the configuration on Switch B serving as a client.
# Configure VLAN-interface 1 to dynamically obtain an IP address from the DHCP server.
<SwitchB> system-view
[SwitchB] interface vlan-interface 1
[SwitchB-Vlan-interface1] ip address bootp-alloc
# Use the display bootp client command to view the IP address assigned to the BOOTP client.
NOTE:
To make the BOOTP client obtain an IP address from the DHCP server, you must perform additional
configurations on the DHCP server.
Advertising
This manual is related to the following products: