Enabling dhcp – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 42
31
By configuring self-defined DHCP options, you can
•
Define new DHCP options. New configuration options will come out with DHCP development. To
support these new options, you can add them into the attribute list of the DHCP server.
•
Define existing DHCP options. Vendors use Option 43 to define options that have no unified
definitions in RFC 2132. The self-defined DHCP option enables DHCP clients to obtain
vendor-specific information.
•
Extend existing DHCP options. When the current DHCP options cannot meet the customers’
requirements (for example, you cannot use the dns-list command to configure more than eight DNS
server addresses), you can configure a self-defined option for extension.
Follow these steps to configure a self-defined DHCP option in the DHCP address pool:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter DHCP address pool view
dhcp server ip-pool pool-name
[ extended ]
—
Configure a self-defined DHCP
option
option code { ascii ascii-string |
hex hex-string&<1-16> |
ip-address ip-address&<1-8> }
Required
No DHCP option is configured by
default.
Table 2 Description of common options
Option Option name
Corresponding command
Command parameter
3 Router
Option
gateway-list ip-address
6
Domain Name Server Option
dns-list ip-address
15 Domain
Name
domain-name ascii
44
NetBIOS over TCP/IP Name
Server Option
nbns-list ip-address
46
NetBIOS over TCP/IP Node Type
Option
netbios-type hex
66
TFTP server name
tftp-server ascii
67 Bootfile
name
bootfile-name ascii
43
Vendor Specific Information
—
hex
Enabling DHCP
Enable DHCP before performing other configurations.
Follow these steps to enable DHCP:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enable DHCP
dhcp enable
Required
Disabled by default.