Emerson Process Management ControlWave EFM 3808 - Manual (Page 59)

CI-ControlWave EFM Installation & Operation / 2-7
Once the program has been created, it is assigned to an executable task. The entire project
is then saved and compiled.
NOTE: From this point on, the order of steps may be varied, somewhat,
depending upon the requirements of the user's application.
NOTE: If you modify the standard EFM program, you may need to modify the
standard web pages associated with it. (See Step 5, below).
Step 5. Use Standard Web Pages Provided to Select Options in the Standard
Control Strategy
The ControlWave EFM has a standard set of web pages for configuration purposes (stored
on a PC) that lets you enter parameters, and configuration options for the standard EFC
program (see Step 4, above). If you modify the standard EFM program, you may need to
modify the standard web pages. If you create your own application program (instead of
using the standard one), you may create your own web pages using Bristol ActiveX controls
discussed in the Web_BSI Manual (document # D5087).
You can use whichever HTML creation package you want to create the pages, however, all
ControlWave EFM related web pages (whether standard or user-created) must be viewed
within Microsoft® Internet Explorer. Web pages are stored on a PC workstation.
Step 6. Create an Open BSI Network Containing the ControlWave EFM, or ADD
the ControlWave EFM to an Existing Open BSI Network
In order for the ControlWave EFM unit to function as part of a Bristol Babcock network, it
is necessary to include it in the Bristol Babcock network.
If no Bristol network exists:
You need to run Open BSI’s NetView software on the PC workstation in order to define
a Bristol network. A series of software wizards are used to define a Network Host PC, a
network, and the RTUs (controllers) assigned to the network. Finally, communication
lines must be specified which handle the address assigned to the Control-Wave EFM.
Chapters 3 and 4 of the Open BSI Utilities Manual (document # D5081) include ‘quick
start’ examples for performing these steps. More detailed information is included in the
NetView chapter (Chapter 6) of D5081.
If a Bristol network already exists:
You will need to add the ControlWave EFM to the existing network using Net-View’s
RTU Wizard. Chapter 6 of the Open BSI Utilities Manual (document # D5081) includes
different sub-sections depending upon whether you are adding the unit to a BSAP
network, or an IP network.
Step 7. If applicable, download new or modified control strategy (OPTIONAL)
If you modified the standard EFM program, or substituted your own program, compile and
download the new or modified program into the unit, using either ControlWave Designer, or
the Open BSI 1131 Downloader. In this case, you download the control strategy into the
BOOT project area of FLASH memory; this ensures that if the ControlWave EFM is reset,
or if there has been a failure of the backup battery, the control strategy can be restarted
from the beginning, i.e. from the BOOT project in FLASH memory. To download the project,
see Section 2.4.1.