Sony ILCA-99M2 - Manual (Page 389)

Do not use/store the product in the following places
In an extremely hot, cold or humid place
In places such as in a car parked in the sun, the camera body may become deformed and
this may cause a malfunction.
Storing under direct sunlight or near a heater
The camera body may become discolored or deformed, and this may cause a malfunction.
In a location subject to rocking vibration
Near strong magnetic place
In sandy or dusty places
Be careful not to let sand or dust get into the product. This may cause the product to
malfunction, and in some cases this malfunction cannot be repaired.
In places with high humidity
This may cause the lens to mold.
On storing
Always attach the lens front cap or body cap when you are not using the camera. To prevent
dust or debris from getting inside the camera, remove dust from the body cap before attaching it
to the camera.
Precaution on carrying
Do not carry the camera with the tripod attached. This may cause the tripod socket hole to
break.
On operating temperatures
Your product is designed for use under the temperatures between 0°C and 40°C (32 °F and 104
°F). Shooting in extremely cold or hot places that exceed this range is not recommended.
On moisture condensation
If the product is brought directly from a cold to a warm location, moisture may condense
inside or outside the product. This moisture condensation may cause a malfunction of the
product.
To prevent moisture condensation when you bring the product directly from a cold to a warm
location, first put it in a plastic bag and seal it to prevent air from entering. Wait for about an
hour until the temperature of the product has reached the ambient temperature.
If moisture condensation occurs, turn off the product and wait about an hour for the moisture
to evaporate. Note that if you attempt to shoot with moisture remaining inside the lens, you
will be unable to record clear images.
On image data compatibility