Rugged Cams Workhorse DVR 16 Channel - Manual (Page 85)

84
On the selection box, select [Partial] using the arrow (WX) and [Select] buttons.
The following figure then appears:
¸ р¼ З ¼ ³Б ¤ Б ц¿ ª¿ ¡ À Мµ ¿ И Д
´ хº нЕ ¬ ¸¯ З С ´Щ .
¸ р¼ З ¼ ³Б ¤ Е © ± в¸¦ Б ¤З С И Д
Е ¬ ¸¯ З С ´Щ .
¸ р¼ З ¿ µ ¿ ªА М И ® Б ¤µ З ¸й ,
´ хº нЕ ¬ ¸¯ З С ´Щ .
Select the area where motion is detected using the arrow (ST) and [Select] buttons.
The user can cancel the selected areas.
¸ р¼ З ¼ ³Б ¤ Б ц¿ ª¿ ¡ ЖД ¶ х»ц
ЖчД ¿ ½ º¸¦ А §Д ¡З С И Д
´ хº нЕ ¬ ¸¯ З С ´Щ .
» иБ ¦З Т ¸ р¼ З ¿ µ ¿ ªА » ¼ ³Б ¤З П°н
Е ¬ ¸ ¯З С ´Щ .
Select the zone and press the [ESC] button.
Selecting the zone
1) To view the zone set in yellow, press the [Select] button.
2) Set the zone using the arrow buttons and press the [Select] button.
3) Once set, the zone is displayed in green.
The [Select] button may be used for toggling.
„ OFF
Disables the detection of motion in the video
„ Setting the motion detection sensitivity
On the {Recording Setup}Æ{Data 1~4}Æ{Event}Æ{Motion} menu, go to the desired channel
using the arrow (STW X) buttons and select the [Main Setup] button. Afterward, right-click
[Motion].
Move the focus to the motion
detection-setting area.
Select zones. Double-click on the selected
zones.
Move the blue focus to the
motion detection-setting
area, and double-click on it.
Select the zone to detect
motions and click on it.click
on it.