TA Triumph-Adler CX 8036 - Manual (Page 86)

Section 3 Scan Mode 3-18
c) and then press “Remove”
2.9 Start
No function at this time in Scan Mode.
All scans in Scan Mode are “Auto Start”.
2.10 Reset / Stop
This button has two functions.
1) Press the Stop button on the Operator Panel to stop the current scan.
After the original has been stopped, press the Stop button again to
eject the document from the scanner or open the scanner lid to remove
the original.
2) Press the Reset button to restore the “default settings” in Scan Mode. Some of the
default settings are determined in the Information / Help Screen
(see Scan Mode Configurations chapter)
2.11 Re-Scan
If the scanned image was not satisfactory, you can replace the last image
scan by selecting this button and proceeding with the scan procedure as
normal.
2.12 View Last
Allows the last scan to be reviewed again on the operator panel.
2.13 Log Off
This button may be displayed if accounting is enabled. Press this button to
log off the current user after the scanning has been completed.