Sony Signature Series NW-WM1ZM2 Walkman Digital Music Player - Manual (Page 27)

27
Storing the Camera Settings
in Memory
– Preset Feature
Settings, including the camera position, zoom,
focus, and backlighting, can be stored in a
preset.
You can also store the presets from Web App or
VISCA/CGI commands.
Note
The camera supports up to 256 presets. The
number of presets that are supported will vary
depending on the device used.
– For the RM-IP500 (sold separately), up to 100.
– For the RM-IP10 (sold separately), up to 16.
– For the remote commander (supplied), up to 3.
– For a Web App, up to 100 positions.
– For VISCA command, up to 100.
– For CGI command, up to 256.
For details on the camera settings that can be
preset, see “Preset Items and Image Setting File
Items” (page 94).
Storing the camera status
1
Press the P/T RESET button to reset the
pan/tilt position.
2
Adjust the position, zoom, and focus of the
camera (See page 26).
3
Hold down the PRESET button and press
any of the 1 to 3 buttons, in which you want
to store the settings.
Note
Before you store the position, zoom, focus, etc.
of the camera, make sure to install and secure
the camera in place to use it properly.
Recalling the stored status
Press any of the 1 to 3 buttons in which you have
stored the settings.
Notes
• When the pan/tilt position is set to PRESET1,
the camera moves to the PRESET1 position at
startup.
• Storing or clearing the settings in PRESET 1
takes about 2 seconds longer than for other
preset operations.
• When you are storing or clearing the settings in
one PRESET, you cannot restore, store, or clear
the settings in another PRESET.
• For details on the items that can be cleared
from the memory, see “Preset Items and Image
Setting File Items” (page 94).
• You can register or delete the preset even while
the OSD menu is being displayed.
• Note that if you change the image flip setting,
the set preset will be cleared.
• The supplied remote commander does not
have the function to remove the preset
memories. Therefore, remove the memories
using Web App, VISCA/CGI commands, or the
remote controller (sold separately), or
overwrite the memory on the same position.
While holding
down
Press the
number button
you want to set.