Sony Signature Series NW-WM1ZM2 Walkman Digital Music Player - Manual (Page 67)

67
Gain 0/3/6/9/12/15/18/
21/24/27/30/33/36
(When high-
sensitivity mode is
set to Off)
0/3/6/9/12/15/18/
21/24/27/30/33/36/
39/42/45/48 (When
high-sensitivity
mode is set to On)
Select the gain.
This function can be selected only when [Mode] is set
to [Manual].
AGC Limit 9/12/15/18/21/24/
27/30/33/36 (When
high-sensitivity
mode is set to Off)
21/24/27/30/33/36/
39/42/45/48 (When
high-sensitivity
mode is set to On)
36 Select the maximum gain value of automatic
exposure control. This function can be selected only
when [Mode] is set to [Full auto], [Shutter priority], or
[Iris priority].
You cannot set a value lower than [Gain Point Level].
Gain Point On/Off Off When you set the lower limit of the shutter speed to
be lower than the output image frame rate, the
shutter speed controls exposure based on the [Gain
Point] setting. Normally, when exposure is adjusted
with sensitivity, noise is prominent when sensitivity is
increased to brighten the image. You can decrease
noise by adjusting the exposure through lower
shutter speeds instead of adjusting with sensitivity.
For this exposure adjustment, enable [Gain Point] and
set the sensitivity value to be changed to the shutter
speed in [Gain Point Level]. When the shutter speed
reaches the lower limit for exposure adjustment, the
sensitivity will increase again to adjust exposure. This
setting is available when [Mode] is set to [Full auto] or
[Iris priority].
Gain Point Level 0/3/6/9/12/15/18/
21/24/27/30/33/36
(When high-
sensitivity mode is
set to Off)
0/3/6/9/12/15/18/
21/24/27/30/33/36/
39/42/45/48 (When
high-sensitivity
mode is set to On)
When the sensitivity during exposure adjustment
reaches the value of [Gain Point Level], the exposure
will be adjusted through a lower shutter speed.
You cannot select a value that exceeds [AGC Limit].
This setting is available when [Mode] is set to [Full
auto] or [Iris priority] and the checkbox of [Gain Point]
is selected.
Shutter Speed 1/1 to 1/10000 1/60 (in the case of
1/59.94)
1/50 (in the case of
50)
1/30 (in the case of
29.97)
1/25 (in the case of
25)
1/48 (in the case of
23.98) Select the shutter speed.
This function can be selected only when [Mode] is set
to [Shutter priority] or [Manual].
Note
When you switch to a shutter speed value that had
been changed greatly, it may take some time to apply
the setting value.
During that time, the setting value on the display
does not match the actual setting value. By reloading
the web browser, the correct setting value is
displayed.
Menu item Detail and setting
value Initial setting value
of the factory
default setting Content