FARGO electronic L000286 - Manual (Page 151)

RESTRICTED USE ONLY Fargo Electronics, Inc.
CardJet 410 Card Printer/Encoder and Persona CardJet C7 Printer User Guide (Rev. 6.1) 4-52
Using the Verification option under Magnetic Encoding
Use the Verification option, which instructs the Printer to verify that all magnetic data has
been correctly encoded on each card. (Note: With either of these options, the number of
verification retries can be specified. A range of 1 to 5 retries is available.)
Step Procedure
1 Select the Auto Eject 1st Error option, which instructs the Printer to
automatically eject a card containing miss-verified magnetic data (that cannot be
verified). (Note: This option is helpful since magnetic stripe verification can at
specific times require more than a single pass.)

Manual Eject mode: Only the first miss-verified card would be automatically
ejected. If a second consecutive card cannot be verified, the Printer will
signal an error and go into a Manual Eject mode.

Auto Eject option: The Auto Eject option is the most direct means of
dealing with miss-verified cards. However, it may be undesirable (if batch
printing) since miss-verified blank cards are ejected into the same stack as
verified printed cards.
OR
Select the Manual Eject Each Error option so the Printer will signal an error on
its LCD display (stating that the magnetic data could not be verified). (Note:
When this occurs, press the Cancel soft key to manually eject the miss-verified
card.)