FARGO electronic L000286 - Manual (Page 19)

RESTRICTED USE ONLY Fargo Electronics, Inc.
CardJet 410 Card Printer/Encoder and Persona CardJet C7 Printer User Guide (Rev. 6.1) 2-10
Technician Review of Printer Features (continued)
Function Description
Ink LED The Ink Cartridge Status LED is described below:
The Ink LED light indicates when you need to check the status of the color or
black Ink Cartridge. (Note: Both Ink Cartridges must be installed in order for
the Printer to function.)

Light is off. When the light is off, both Cartridges are ready for printing.

Ink LED light is lit. When the Ink LED light is lit, it indicates that ink is
not installed, ink is out or that there is a problem with one of the Ink
Cartridges. In this case, correct the issue and close the Printer's Top
Cover to resume operation. When lit, the amber LED above this symbol
will flash to indicate you need to check the status of the Ink Cartridges.
This LED will flash when:

The Top Cover is open. When open, the Ink Cartridge will move to the
install position. Regardless of the Ink Cartridge condition, the Cartridge
will always move to this position. (Note: When the Top Cover is closed,
the Cartridge will return to its home position. If a print job has been
received, printing will resume when the Top Cover is closed. If the Top
Cover is left open, the Cartridge will return to its home position after 5
minutes of the Printer sitting idle.) See CardJet Engineering Drawing
R400019 in the appendix.

One or both of the Ink Cartridges is improperly installed or missing
and the Top Cover is closed. (Note: When Top Cover is opened, the
Cartridge will move to the same standard install position described in
condition 1.)

One or both of the Ink Cartridges is out of ink and the Top Cover is
closed. (Note: When Top Cover is opened, the Cartridge will move to
the same standard install position described in condition 1.)

A non Fargo-certified Cartridge is installed and the Top Cover is
closed. (Note: When Top Cover is opened, the Cartridge will move to
the same standard install position described in condition 1.)
Troubleshooting Instructions. See Section 2):
1. Correct the condition and close the Top Cover to continue printing.
See the Interpreting the LED Lights procedure.