FARGO electronic L000286 - Manual (Page 90)

RESTRICTED USE ONLY Fargo Electronics, Inc.
CardJet 410 Card Printer/Encoder and Persona CardJet C7 Printer User Guide (Rev. 6.1) 3-16
Reviewing the Error Messages for the Magnetic Encoding Module
Mag
Message Problem Solution
Card Jam in
Encoding
Module Indicates a card is jammed in the
Magnetic Stripe Encoding module. Reposition the card under the
encoder
’
s roller and click on the
Retry button to try encoding
again.
OR
Click on the Cancel button to
cancel encoding.
Unable to
Verify
Magnetic
Data Indicates the Magnetic Data
encoded on the current card could
not be verified. Click on Retry to try verifying
again.
OR
Click on Cancel to cancel
encoding. (Note: In most cases,
verify errors are due to a defective
magnetic stripe.)
Magnetic
Data Error Indicates the data sent to the
Magnetic Encoder contains errors.
The current encoding job cannot be
completed. Click Cancel and remove the card
from the Encoding Module.
Be sure to format the Magnetic
Encoding data according to the
instructions in the Online
Operator
’
s Guide.
Cancelled
Card in
Encoding
Module Indicates the encoder will feed in
reverse a short distance to see if the
card is still in the unit.
If it is still in the unit, the card are
moved to the Home / Error position
and the following message will
appear: Cancelled Card in
Encoding Module
After the Cancel button is clicked,
there is a cancelled card in the
Encoding Module.
Remove the cancelled card from
the Encoding Module by grasping
the end of it and pulling it out.
Be sure to separate this card from
the cards that encoded
successfully.
Continued on the next page