FARGO electronic L000286 - Manual (Page 56)

RESTRICTED USE ONLY Fargo Electronics, Inc.
CardJet 410 Card Printer/Encoder and Persona CardJet C7 Printer User Guide (Rev. 6.1) 2-47
Technician Handbook for CardJet Card Printers (continued)
Topic Description
Fargo
Controller to HP
Sensor
Assembly There are two (2) cables which connect the Fargo Controller with the
Sensor in the HP Print Engine. These cables must be properly attached
for the Printer to operate properly.
Illegal Ink
Cartridge
Detection (via
Ink LED) The Printer correctly validates the replacement Cartridge and reports
that it is an illegal Cartridge via the Ink LED

before running out of ink
and having a new Ink Cartridge installed.
The printing is restarted when the Ink Cartridge is replaced with a good
Cartridge.
Image
Positioning Use the Image Position controls to adjust the position of the overall
print area to be precisely centered on a card.
Improperly
installed color
Ink Cartridges The Printer correctly detects an improperly installed color Ink
Cartridges

when the empty color Cartridge is replaced in the Printer
(but it is installed incorrectly).
Improperly
seated Card
Cartridge
(See Card LED
and Error
Messages)
The Printer correctly detects and reports improperly loaded Card
Cartridges via the Card LED and on-screen message

when the Card
Cartridge is improperly seated. (Note: The Card LED begins to blink
indicating an error.)
A PC screen pop-up is displayed: The card Cartridge is not
installed.
Troubleshooting Instructions. See Section 2):
1. Correctly load the Card Cartridge to cancel the error conditions.
2. Install the Cartridge, then press the Card button on the front of the
Printer to print or cancel printing.
Incorrect Card
Cartridge
Detection (See
Card LED) The Printer correctly validates a replacement Cartridge and reports that
it is an illegal Cartridge via the Card LED

before running out of cards.
The printing will continue when the Card Cartridge is replaced with a
legal Cartridge.
Continued on the next page