FARGO electronic L000286 - Manual (Page 96)

RESTRICTED USE ONLY Fargo Electronics, Inc.
CardJet 410 Card Printer/Encoder and Persona CardJet C7 Printer User Guide (Rev. 6.1) 3-22
Troubleshooting the Card Jam
If a card becomes jammed inside the Printer, the Card LED light will flash and the Printer will
pause operation. Refer to the following steps for instructions to clear the jam:
Step Procedure
1 Leave the power ON and open the Printer's Top Cover.
2 Remove the Card Cartridge.
3 Locate the jammed card and remove it from the Printer.
4 Press the Card button to resume printing.
5 Close the Top Cover and reload the Card Cartridge.
Troubleshooting with the Host Driver Download Software
Step Description
1 Troubleshooting as follows:

Software downloaded: The host Driver download software automatically
opens and prompts the Operator through the Driver installation process when
the Driver CDROM is loaded into the PC.

Technician Note: Ensure that device initialization and Firmware downloading
occur when Printer start-up is initiated and cards are printed with acceptable
color reproduction and image placement when the Operator initiates a print
job following Driver installation.
Troubleshooting with an open Printer Top Cover
Step Description
1 Troubleshooting as follows:

Open Printer Top Cover: When a print job and the Printer is initiated with
normal conditions and the Printer Top Cover is opened during the print
process, the Firmware will trap the condition and will put the Printer into a
Safe Pause mode.

Technician Note: Ensure that the Printer will restart the operation and will
continue printing cards after the Operator closes the Printer Top Cover. See
CardJet Engineering Drawing R400019 in the appendix.