FARGO electronic L000286 - Manual (Page 27)

RESTRICTED USE ONLY Fargo Electronics, Inc.
CardJet 410 Card Printer/Encoder and Persona CardJet C7 Printer User Guide (Rev. 6.1) 2-18
Technician Review of CardJet Card Printer Setup
IMPORTANT! Fargo Card Printers require highly specialized print supplies to function
properly. To maximize Printer life, reliability, printed card quality and durability, you must use
only Fargo Certified Supplies. For this reason, the Fargo warranty is void, where not
prohibited by law, if you use non-Fargo Certified Supplies. To order additional materials,
please contact the Fargo authorized reseller.
Selecting an area for the Card Printer
Step Procedure
1 Place the unit in a location with adequate air circulation to prevent internal heat
build up.
2 Use the Printer's dimensions as a guideline for the minimum clearances to the
unit. (Note: Allow for adequate clearance above the unit to accommodate the
height of the unit with its Top Cover open.)
3 Do not install unit (a) near heat sources such as radiators or air ducts or (b) in a
place subject to direct sun-light, excessive dust, mechanical vibration or shock.
4 Read carefully the caution about moisture condensation.
Caution: If the unit is brought directly from a cold to a warm location or
is placed in a very damp room, moisture may condense inside the unit. (Note:
Should this occur, print quality may not be optimum. Leave the unit turned OFF
in a warm, dry room for several hours before using. This will allow the moisture
to evaporate.)