FARGO electronic L000286 - Manual (Page 176)

RESTRICTED USE ONLY Fargo Electronics, Inc.
CardJet 410 Card Printer/Encoder and Persona CardJet C7 Printer User Guide (Rev. 6.1) 5-3
Additional Safety Precautions for CardJet Technicians (review
carefully)
Symbol Critical Instructions for Safety purposes
Danger: Before operating the unit, please read the following safety
precautions carefully:

Fire or Shock Hazard: Prevent fire or shock hazard by not
exposing the unit to rain or moisture.

Electronic Shock: Reduce the risk of electronic shock by not
removing the front, top or back Panels. No Operator-serviceable
parts inside. (Technician Note: Refer servicing to qualified
service personnel.)

Correct Voltage Rating: Operate the unit only on 100-240 VAC,
50/60 Hz. (Technician Note: If you have any doubt as to whether
you have a unit with the correct voltage rating for the country's
power supply, DO NOT attempt to use the unit. Contact the dealer
or the factory.)

Liquid or Solid Object: Stop operation immediately if any liquid
or solid object should fall into the cabinet. (Technician Note:
Unplug the unit and have it checked by qualified service
personnel.)

AC power cord: Use only the AC power cord included with this
unit or an equivalent cord.

ESD procedures: Be sure to observe all established Electro-
Static Discharge (ESD) procedures while handling cables in or
near the Circuit Board.

Grounding Device Safeguards: Always wear an appropriate
personal grounding device, such as a wrist strap with integral
resistor, connected to an ESD ground to avoid potential damage.

Electrostatic Sensitive Device: At a minimum, make positive
contact with the bare metal chassis of the Printer with the hand
before proceeding with the procedure. (Technician Note: This
device is electrostatic sensitive. It may be damaged if exposed to
static electrical discharges. Discharges may be generated by
various means, such as walking on a carpeted floor.)