FARGO electronic L000286 User Manual
Page 52
RESTRICTED USE ONLY
Fargo Electronics, Inc.
CardJet 410 Card Printer/Encoder and Persona CardJet C7 Printer User Guide (Rev. 6.1)
2-43
Technician Handbook for CardJet Card Printers (continued)
Topic
Description
Card Printing
Jam
The Firmware correctly detects the condition and indicates a fatal error
condition via Card LED and a PC on-screen error message via the
Driver Operator Interface
when a print job and the Printer are
configured with anomalous conditions intended to induce a card printing
jam.
Troubleshooting Instructions. See Section 2):
After an error has been detected and reported, you can open the
cover, remove the jammed card and then close the cover and press
the Card button to continue the print job starting with a fresh card.
Card Sensor
condition (turns
LED on/off;
both 410/C7
models)
The Fargo Controller turns the LED on/off depending on the Card
Sensor condition. See the
procedure.
(Note: When no card is present, the LED is on
and nothing interrupts
the IR emission.)
This Sensor is described as follows:
Detect card jam: The Card Sensor is used to determine the card
position in case of a jam, as well as for service purposes.
Detect card edge: The Fargo Controller detects if there was a
leading or trailing edge of a card detected.
Continued on the next page