Fujitsu Siemens Computers BS2000/OSD - Manual (Page 36)

36 U25339-J-Z126-1-7600
Invoking an SVP frame Standard processing in SVP mode
The password entry window is displayed:
Figure 9: SVPST0 #1 window (password entry)
Ê Enter the password for the specified user ID and press .
If the correct password has been entered, the following window appears after a short pause:
– after starting the S130: the MODE SELECTION FRAME (see page 47)
– after closing and reopening the “SVPST0 #1” window or
opening another SVP window on the secondary console: the last frame shown in the
“SVPST0 #1” window.
If the “SVPST0 #1” window or another SVP window on the secondary console is
opened, the contents of the window are not output completely. Press the
key.
This causes the screen to be refreshed, i.e. the frame that was last output is
displayed again in its entirety.
ENTER
!
K2