Fujitsu Siemens Computers BS2000/OSD - Manual (Page 86)

86 U25339-J-Z126-1-7600
IPL in PROGRAM LOAD FRAME: DETAIL-1 Standard processing in SVP mode
DETAIL-2 STATUS The settings in DETAIL-2 FRAME are displayed in
detail.
Check the settings. If they are correct, execute the
IPL (see below), if not, correct the entries in
DETAIL-2 FRAME (see section “Setting operating
mode via PROGRAM LOAD FRAME: DETAIL-2” on
page 87).
In our example VM MODE: NATIVE , i.e. the firmware
for the BS2000 operation is loaded. This setting
must be changed in DETAIL-2 FRAME for this
example.
Swap to PROGRAM LOAD FRAME: DETAIL-2
Ê Press the key.
This saves the entries in DETAIL-1 FRAME in the SVP and opens the DETAIL-2
FRAME.
Execute IPL
Ê Press after you have checked all the settings.
The following prompt appears on the screen:
Press to execute the IPL, or to cancel the procedure. Confirm your entry with
.
P9
ENTER
***********************************
* *
* ARE YOU SURE ? (ENTER Y OR N) N *
* *
***********************************
Y N
ENTER