Fujitsu Siemens Computers BS2000/OSD - Manual (Page 42)

42 U25339-J-Z126-1-7600
Using frames Standard processing in SVP mode
6.3 Using frames
You assign a job to the SVP by invoking the relevant frame, selecting the desired function,
and specifying the required parameters. To select a function or specify a parameter, you
must enter the alphanumeric characters shown in the frame in the input fields marked by an
arrow (
=> ). The input fields can be selected with the tab key . Once you have entered all
the functions and parameters assigned to a job, press the key. In several frames,
functions can also be initiated with the SVP function keys.
Instead of selecting a function, you can also enter a command in the command input line in
all frames (screen line 24) and assign a job to the SVP in this way. Frames can also be
selected using the
FRËFrame-ID , e.g. FR ML (to switch to the MODE SELECTION FRAME).
A command entered in line 24 takes priority over a selected frame function.
General notes on frame operation:
The input is disturbed by the output of messages in line 23 (e.g. SET TIME COMMAND
COMPLETED ). The key suppresses output of the message for one minute. In this time the
frame can be filled out and dispatched with .
6.3.1 SVP function keys
An EMDS keyboard mask, which must be ordered separately, is used to operate the
SVP frames:
Order number: U20076-J-Z148-1
EMDS (SINIX Open Desktop) as of V2.1 for DSS 97801-5xx:
Keyboard masks - 6 strips
The following diagram shows the position and labelling of the SVP function keys on the
EMDS keyboard mask:
You can activate various functions on the SVP frames with the help of the P keys to ,
the keys to and to .
ENTER
K1
ENTER
i
P1 P2 P3 P4 P5 P6 P7 P8 P9 P10
P11 P12 P13 P14 P15 P16 P17 P18 P19 P20
K1 K2 K3
F1 F2 F3
P1 P20
K1 K3 F1 F3