Fujitsu Siemens Computers BS2000/OSD - Manual (Page 91)

U25339-J-Z126-1-7600 91
8 Troubleshooting
This chapter describes what to do out in case of malfunction.
8.1 Problems with the S130
In the case of a problem with the S130, contact the service department and discuss the
steps to be taken. Depending on the outcome of this discussion, you may be required to
carry out the following tasks:
– Take a system dump in the case of an inexplicable system failure.
– Disable defective I/O processors if several I/O processors are available.
You can continue processing with the rest of the system.
– Disable defective processing units, if several are available.
You can continue processing with the rest of the system.
– If one of the MCU, SVP, SCI, SPC, or PCI system components is defective, contact the
service department.
The next section explains how the S130 informs you of hardware errors.
Problems with the S130 page 91
Displays if there is a hardware error page 92
Carrying out a system dump page 93
Measures to take if there is an I/O processor failure page 93
Measures to take if there is a processing computer failure page 94
Problems with the service/console processor (SKP) page 97